Tianjin Jinda Zhengyuan Energy Saving and Environmental Protection Technology Co., Ltd.

Cleaning Agent
Product Features:
It is a high-quality liquid cleaning agent specially designed to remove organic sludge and other particles attached to the surface of polyamide, polysulfone and thin film component membranes. .
This high-efficiency cleaning agent has the following characteristics:
, formulated with high-performance polymers
, liquid formula is easy to operate and dilute
, can be used at room temperature and higher temperatures Highly efficient
, suitable for all membranes except cellulose acetate membrane
, simple flushing and restarting system
, adjustable
Product properties:
Sales Telephone:
The following are typical properties but should not be considered as indications of product availability. Product specifications available on request.
<= dd Appearance
Amber liquid
Odor
Slight

(% liquid)
Calculate Density
Cleaning Guide:
<= dd
Check the flush tank pipeline and filter element and drain the reverse osmosis system as much as possible.

Fill the entire cleaning tank with demineralized or permeated water. Add gallons (liters) per four inches of component Add gallons (liters) per inch of component.

Add solution to the cleaning tank again and slowly add gallons per gallon of water (or liter/liter).

Heating the cleaning solution can improve cleaning efficiency (do not exceed).

Open the concentrate valve to allow the solution to pass through the diaphragm tank at the flow rate and water inlet direction recommended by the membrane or system supplier.
If the data recommended by the supplier cannot be used, the guidance parameters in the table below can be used.
<= dd membrane diameter ()
Flow rate of each membrane tube (parallel to the water flow) /
/



.Operation Time is in minutes.
.Additional soaking minutes.
.If the cleaning solution becomes turbid or discolored, it needs to be replaced with fresh solution. This solution must be prepared before additional cleaning processes.
.Waste liquid is used to clean the reverse osmosis system.
. Keep the return concentrated water valve in working condition and run the reverse osmosis system until the permeate regains its quality and then drains the water.
Operations and Logistics:
Please read the Terms and Materials Safety before using the product.
Classification: The transportation hazard level is level
Corrosive to eyes and skin
Packing specifications:
This product is a liquid product and is packed in a special plastic barrel. The packaging specification is/barrel storage period for one year.