Cleaning agent <= d%>
<= d%> Product Features
:
It is a low-intensity formula specially designed to remove metal hydroxides, calcium carbonate and other similar attachments Scale on polyamide, polysulfone and thin film component membrane surfaces. This high-efficiency powder has the following characteristics:
, ..adjustable
, efficient at room temperature
, contains no surfactants and is easy to rinse
, contains organic acids, and is washable agents and chelating agents.
Suitable for membranes of all polyamide, polysulfone and film components. It is suitable for temperatures from degrees to the maximum recommended by the membrane manufacturer. The standard dilution ratio is grams dissolved in liters of water.
Cleaning Guide:
Check the cleaning tank pipeline and security filter. Install new filter element.
Add the reverse osmosis produced water into the cleaning tank.
Add slowly at the ratio of liters of water to grams.
Mix the cleaning solution thoroughly with a mixer or by circulating the solution with a cleaning pump.
The solution can be heated to enhance the cleaning effect.
, Do not exceed the membrane manufacturer's temperature limits.
Use the flow rate recommended by the membrane manufacturer or system manufacturer to inject the solution from the same direction as the incoming water and circulate it for hours. The following guidelines can be used as a reference if not recommended by the manufacturer.
Rolled Membrane
<= dd Membrane Diameter (inches)
Flow rate of each membrane tube (parallel to the water flow)/(US Gallons per minute)
< br/>
Hollow fiber membrane
<= dd membrane diameter ( inches)
Flow rate per element (parallel direction)/(US gal/min)
In case of severe fouling, initial backflow (accounting for % of the cleaning tank volume) should be drained to prevent redeposition of the removed solids.
In a multi-level system, if each level of the system is cleaned separately, the best effect will be achieved.
If the solution becomes turbid or discolored during cleaning, it should be drained. New solutions should be prepared before cleaning each stage of the system.
. The system should be thoroughly cleaned with produced water before restarting.
Packaging specifications
:
This product is a liquid product and is packaged in a special plastic barrel. The packaging specification is/barrel.
Great Lakes Floclean MC3 cleaning agent